|
Cutting the stone : Topaz (Light Blue), Mt Surprise, Barion Old Mine, #45
What I wanted to do here was to give you an idea of how a stone gets cut. The stone starts off in the "rough" and is attached to a short brass rod called a "dop" using hot wax. The dop is inserted into the "quill" which can be rotated in increments.
The quill can be set at certain angles and in some of the photos you can see the digital angle read out. Precision cutting gems, ie. faceting, is all about correct and accurate angles.
I generally start out cutting the bottom of the gemstone, which is called the "pavilion". The "girdle" comes next which is the middle belt around the gemstone. After this, the stone is then "transferred" onto a second dop and the cutting of the top half, the "crown", is done.
Finally the "table" which is the top surface of the gem is cut.
Once completed, the stone is then removed from the dop, cleaned to remove all the traces of wax and then its ready to sparkle.
The rough stone is affixed to the dop. |
|
|
Its a big piece of topaz with alot of grinding to be done. |
|
|
Cutting the pavilion... |
|
|
Working on the girdle. |
|
|
Okay, we can start to see the pavilion taking shape. |
|
|
Polishing the pavilion. |
|
|
Very nice! |
|
|
Transfering the stone to the second dop. |
|
|
Ready to start cutting the crown. |
|
|
Cutting the crown. |
|
|
Getting there... |
|
|
Shot showing the shape of the gemstone. |
|
|
The crown has been polished. |
|
|
Ready to start cutting the table. |
|
|
Cutting the table. |
|
|
Finished polishing the table. |
|
|
Looking good. We've finished cutting and polishing. |
|
|
